Open the IP search software, press startī.
NICEHASH ZCASH MINER CONFIGURATION SOFTWARE
Then download the IP search software here: and look for IP Reporter as belowĪ.
Power up the miner and wait for the normal (green) light to start flashing before searching for the miner’s IP address. Check that you are using two C13 power connectors and connect them to 220V AC outlet.
Ensure the Ethernet crystal head connector is plugged.Ģ. Inspecting the miner ’ s cables and connectorsġ. Reset > To reset miner to factory settings Normal > Indicates miner is operating normally IP Report > Press this to use the IP Report software to show the miner’s IP address on the computerįault > Fault light beams when a miner error is detected If you found loose heat sinks, contact customer support immediately.Ģ) Only Ethernet network connection supported via a router or switch.ģ) Use the miner in an environment between 5 to 35 degree Celsius.Ĥ) Keep the miner’s surrounding humidity below 65%ĥ) Keep the miner free of dust and catkins to prevent corrosion and/or heat accumulation.Ħ) Supported browsers: Google Chrome and Firefox.ħ) Power connector and PSU cord must be plugged tightly. View from miner’s front and rear fan to check whether there are loose heat sinks. If you noticed a damage or defect, contact customer support immediately.ģ. Look out for broken fan blades and cables. Look at the corners of the miner and check for dents and cracks. If miner is damaged as well, contact customer support immediately.Ģ. If package is damaged, take photos of the package’s conditions before proceeding to open the package and inspect the miner. Visually inspect the box when your miner package arrives.
0 kommentar(er)
